Home  FAQs Simple Mechanical Seal
|
|
เขียนโดย Admin
|
|
Thursday, 26 July 2007 |
|
Mechanical Seal | The mechanical seal shown in above is a simple light-duty design. The sealing interface where the mechanical seal rotating and stationary faces make rotational contact is a plane annulus. The sealing faces themselves are lapped to a very high degree of flatness, measured in wavelengths of light. The body of the rotating component of the mechanical seal is free to float axially. This enables hydraulic pressure to keep the main sealing faces together in operation; in the absence of hydraulic pressure the spring serves the same purpose
|
The closing force on the seal is designed to provide an acceptable compromise between leakage and wear. It must also be sufficient to prevent the faces from separating in the event of mechanical shock or a pressure fluctuation. A secondary seal prevents leakage between the floating assembly and the shaft; often a rubber `O' ring is used for th this purpose. | Weak Spring Load |  | | Result = Unacceptable Leakage |
Excessive Spring Load |  | | Result = Unacceptable Seal Life |
|
|
|
แก้ไขล่าสุดเมื่อ ( Monday, 08 December 2008 )
|
|
|
Who's Online
ขณะนี้มี 4 บุคคลทั่วไป ออนไลน์
|
